Making sure your power tools are protected from any harsh elements that can damage them can take its toll sometimes. Basements and garages is not an ideal place to keep your power tools because of its humidity By following a few simple procedures you can spend more time woodworking and less time fussing over your rusty tools.

To get superb advice and other guidance involving woodworking plans consider my other information sites here woodworking plans

Power tools are always covered with a protective coating called cosmoline and you can always see this on a newly purchased tools . Once it is in your shop, this coating must be removed and your cast iron top is no longer protected. Too many times anxious woodworker remove all of the Cosmoline without thinking about the ongoing protection of their investment.

In order for us to protect the cast irons we need to coat them again to keep the moisture away . Commercially made rust preventive products can be the easiest way to do it. Two of the most popular brand are the Boeshield T-9 and Empire Top Saver.Both of these sprays are applied directly to the surface and then rubbed down to remove the excess. This step should be repeated periodically to keep a layer of protection on the tool.

The unfortunate reality of tool ownership is that despite every good intention, tools left unprotected will eventually develop rust. And we left it alone for a long time it will definitely damage the whole of it.

This is the jointer that is not sprayed with any rust protection. The accumulation of dust particles are now inviting rust to settle in this tool. In 2 years time this tool will be unserviceable.

In the earlier days people still use a steel wool to remove rust but how about the dust that is settled where the wool can't reach . Fortunately, there are products available that can make this job a lot easier and more effective.

A product called Rust Free by Boeshield is a rust remover that quickly removes rust. This spray on rust remover works well on the tops of tools that are too large to soak in rust removal solutions. Just spray , wait 1 minute and wipe.. Use a steel wool to remove the remaining rust.

After these steps the jointer will now be rust free and is ready for the second stage of rust protection . If you look closely you can see a small rust pit. These pits are the unavoidable consequence of the rust. There is no way that a rust removal can repair a rust pit.

Most rust removal sprays contain some type of acid. These acids will dissolve rust very quickly and the metal very slowly. When using Rust Free or any other spray, be sure to wear safety goggles and gloves to avoid contact with eyes and skin.

These methods can definitely help you preserve your power tools for a long time .